Find helpful information about your LG Product through our Help Library. Find helpful information about your LG Product through our Help Library.

Help Library

Find helpful information about your LG product

[LG Front Loader] How to Clean the Tub

Troubleshooting

Why does the tub smell strange?

➔ LG’s antimicrobial washer tub is designed to suppress the growth of microorganisms.

However, if the appliance is used for an extended period in a humid, shaded environment, bacteria and fungi in the air can adhere to the water stains on the tub.
Without proper maintenance, the tub may become contaminated and develop an unpleasant odor.
Additionally, excessive use of fabric softener can also contribute to the tub smelling bad.

Try this

Use fabric softener in moderation, following the manufacturer’s guidelines.

The recommended dosage according to load is written on the label of the fabric softener.

Run the Tub Clean cycle after every 30 uses of the washer, or whenever the display shows "tcL."

The code tcL is being shown on the washer’s display.
How to run Tub Clean/Tub Sterilization
Before starting the cleaning cycle, ensure the tub is free of laundry.
1. Add oxygen-based washing machine cleaner to the washer, following the manufacturer’s recommended dosage and instructions.
Avoid using chlorine-based or acidic washing machine cleaners, as they may cause discoloration or corrosion inside the machine.
2. Using the control panel, select the [Tub Clean] or [Tub Sterilization] cycle and press the start/pause button.
(The location of the button and its exact name may vary by model.
This guide serves as a general reference. Please consult the product user manual for detailed information.)
※ Hot water is supplied for the Tub Clean cycle and the water temperature is maintained at 60°C.
If hot water cannot be supplied, he washer’s heater will warm up cold water.
In models with a steam feature, steam is injected into the tub.
① Standard model
Selecting the Tub Clean cycle by rotating the dial.
② LCD Dial Model
Turn the LCD dial to select [Tub Clean] and press the start/pause button to proceed with cleaning.
Turning the LCD dial to select Tub Clean and pressing the Start button.
③ LED type WashTower model
Touch and hold the [Tub Clean] button on the control panel for 3 seconds and press the start/pause button.
Location of the Tub Clean button on an LED type WashTower model.
④ LCD type WashTower model (newer model)
Select the [Tub Clean] cycle from the LCD panel ad press the start/pause button.
Selecting the Tub Clean cycle on an LCD type WashTower model.
Wait! Find out more.
Once the cycle ends, immediately remove the laundry from the washer.
Open the door and dispenser drawer after washing to allow the interior to dry.
Ensure the tub remains empty when not in use.
Using a door holder can help keep the washer free of odors by allowing air to circulate inside the tub.
Opening the washer door and detergent drawer for air circulation.
How to use the door holder
Close the washer door gently, until the door holder touches the front of the washer.
The door holder is equipped with a magnet, which allows it to stick to the front side of the washer, keeping the door ajar.
An image of the dryer door being slightly ajar and a close-up image of the door holder located on the lower, inner side of the washer door.
Caution!

It is recommended to use an oxygen bleach tub cleaner for the Tub Clean cycle.
Using chlorine-based or acidic cleaners can lead to discoloration or corrosion inside the machine.
Tub cleaners that produce excessive foam may cause leaks from the washer.
Therefore, it is advisable to use these cleaners sparingly or opt for a cleaner that produces less foam.

This guide was created for all models, so the images or content may be different from your product.

*Required question